Filter
Top Products
Getting Started Connections Other Operations Multi-Zone Information Troubleshooting SpecificationsSetup
A2 Remote ID
AVC-A1HD
A4 Remote ID
AVP-A1HD
Set remote control ID.
Match the ID setting of the remote control unit and the receiver.
• When changing the remote ID, also change the AMP, iPod and
NET/DTU modes of the main remote control unit at the same time
(v
mpage 70
AVC-A1HD
, mpage 72
AVP-A1HD
).
• When changing the remote ID, also change the sub remote control
unit at the same time (
v
mpage 75
AVC-A1HD
, mpage 77
AVP-A1HD
).
A1 Digital Out
AVC-A1HD
A3 Digital Out
AVP-A1HD
Set usage of OPT4 OUT.
NOTE
The ZONE4 operations cannot be performed when set to “Rec
Select”.
[Selectable items]
ZONE4 Select
Rec Select
[Selectable items]
1
2
3
4
A3 232C Port (1)
AVC-A1HD
A5 232C Port (1)
AVP-A1HD
Set when external controller or 2-way remote control unit (RC-
7000CI and RC-7001RCI, sold separately) is connected.
NOTE
In order to use a 2-way remote control (RC-7000CI or RC-7001RCI, sold
separately), set “2Way Remote”. In this case, the RS-232C terminal
cannot be used for an external controller.
A4 Dimmer
AVC-A1HD
A6 Dimmer
AVP-A1HD
Adjust display brightness of the receiver.
Operating from the main unit
Press the DIMMER button.
[Selectable items]
Bright
Dim
Dark
OFF
Bright Dim
DarkOFF
A5 Setup Lock
AVC-A1HD
A7 Setup Lock
AVP-A1HD
Protect settings from inadvertent change.
• When “Setup Lock” is set to “ON”, the settings listed below can
no longer be changed. Also, “SETUP LOCKED!” is displayed if you
attempt to operate related buttons.
⋅ GUI menu operations
⋅ RESTORER
⋅ Parameters
⋅ MultEQ
®
XT 32
⋅ Channel Level
⋅ Audio Delay
• To cancel the setting, press the MENU button to re-display the “Setup
Lock” screen, then change the setting to “OFF”.
[Selectable items]
ON
OFF
A6 Maintenance Mode
AVC-A1HD
A8 Maintenance Mode
AVP-A1HD
This sets the function for maintenance by a DENON service
person or installer. (For professional use only.)
NOTE
Only use this function if so instructed by a DENON service person or
installer.
This function allows a DENON service person or installer to check the
unit’s status and make settings via the Internet.
[Selectable items]
Serial Control
: Set when using an external controller.
2Way Remote
: Set when using a 2-way remote control unit.