Filter
Top Products
Getting Started Connections Other Operations Multi-Zone Information Troubleshooting SpecificationsSetup
h Trigger Out 1
AVC-A1HD
k Trigger Out 1
AVP-A1HD
Select the conditions to turn on the trigger out 1 with respect to
the zone, input source, surround mode, HDMI monitor, etc.
For details about the trigger out function, see mpage 22.
j Trigger Out 2
AVC-A1HD
l Trigger Out 2
AVP-A1HD
This sets the conditions to turn on the trigger out 2, in the same
way as “Trigger Out 1” above.
k Trigger Out 3
AVC-A1HD
A0 Trigger Out 3
AVP-A1HD
This sets the conditions to turn on the trigger out 3, in the same
way as “Trigger Out 1” above.
l Trigger Out 4
AVC-A1HD
A1 Trigger Out 4
AVP-A1HD
This sets the conditions to turn on the trigger out 4, in the same
way as “Trigger Out 1” above.
[Selectable items]
ON
– – –
Setting with Respect to the Zone
When the power of the zone turned on/off, the trigger out turns on.
Setting with Respect to the Input Source
When the input source set to on is selected, the trigger out turns on.
Associated with respect to the input source for zones set to “ON” at
“Setting with Respect to the Zone”.
A0 Transducer Setup
AVC-A1HD
A2 Transducer Setup
AVP-A1HD
Settings when using transducer.
The Transducer Setup can be accessed through GUI menu “Speaker
Setup” – “Subwoofer Setup” is “1SP”, “2SP L/R” or “2SP MIX”. The
transducer signal is outputted from “SW3”.
Level
[Variable range]
–12dB
~
0dB
~
+12dB
:
Set the transducer level.
OFF
:
Turn the transducer output off.
Setting with Respect to the Surround Mode
When the surround mode set to on is selected, the trigger out turns
on.
Setting with Respect to the Monitor
When the HDMI monitor set to on is selected, the trigger out turns
on.
This is effective when the “MAIN ZONE” has been set to “ON” for
the “Setting with Respect to the Zone” and the input source which is
set to “ON” has been selected for the “Setting with Respect to the
Input Source”.
This is effective when the “MAIN ZONE” has been set to “ON” for
the “Setting with Respect to the Zone” and the input source which is
set to “ON” has been selected for the “Setting with Respect to the
Input Source”.
When you adjust “Level”, the adjusted value is set for all surround
modes. To adjust the level for individual surround modes, use “Channel
Level” (vmpage 65
AVC-A1HD
, mpage 67
AVP-A1HD
).
LPF
Set the upper limit of the low frequency output to the transducer.
[Selectable items]
40Hz
60Hz
80Hz
90Hz
100Hz
110Hz
120Hz
150Hz
200Hz
250Hz