Filter
Top Products
®
Zone Controller Wiring
The DriveRack 260 Zone Controllers, (ZC-1, ZC-2, ZC-3, ZC-4) can be wired serially or in par-
allel. To wire in series each Zone Controller must have an identification or zone number cho-
sen using the DIP switches on the side of the controller (see diagram A). Each controller must
have a unique number chosen although there may be multiple Zone Controllers controlling a
single zone, or a single Zone Controller that controls multiple outputs. The Zone Controllers
can then be wired together and connected to the DriveRack 260 (see diagram B).
The Zone Controllers may also be wired in parallel with the use of the ZC-BOB. To wire in
parallel (home run cabling), each controller must have a unique identification or number cho-
sen using the DIP switches on the rear of the panel (see diagram A). To wire in parallel, each
controller must be wired into a port of the ZC-BOB with a connecting wire going to the
DriveRack 260 (see diagram C).
Remote Control
SECTION 6
DriveRack
™
55
480 User Manual
Diagram A
RJ45
CONNECTONLYTO
ZONECONTROLLER
INPU
T
.
IEC60065
UL-650
0
80-1342-A
RJ45
CONNECTONLY
TO
ZONECONTROLLE
R
INPU
T
.
IEC60065
UL-6500
80-1342-A
18WATTS
100V- 120V 50/60H
z
INPUTS
CH4CH6 CH5PC
POWER
OUTPUOUTPUTS
AHARMANINTERNATIONAL
COMPANYSALTLAKECITY,UTAH
MADE INUSA
MODELDriveRack 260
COMPLETE EQ&LOUDSPEAKER
MANAGEMENT SYSTEM
TM
ZONECONTROLLER
Useonlywitha250Vfuse
Employeruni quementavao
unfusiblede
250V
ID# 1 ID#4
Diagram B