Filter
Top Products
Utilities/Meters
®
46
Section 5
DriveRack
™
®
DriveRack™ User Manual
• To set the program number that will correspond with the index number, press the DATA
wheel. once this is selected, rotate the DATA wheel to select the desired program number.
• Once your program list has been built, press the PROGRAM/CONFIG button to exit.
Program lock means that program numbers below the selected number cannot be overwrit-
ten.
The Utility menu of the 260 DriveRack also provides you with the option of changing the out-
put levels jumpers from 14dB, 22dB and 30dB from the front panel via the Utility menu. These
settings are used by the SETUP Wizard to compute the output gain of the 260. The following
information will walk you through this procedure.
• From Program mode, press the UTILITY button and use the PREV PG and NEXT PG but-
ton to move to the page that appears as follows:
• Rotate the DATA wheel to select the desired output (1-6) to be edited.
• Now press (to select) and rotate the DATA wheel to set the desired output jumper level.
Output Jumpers
Output 1
Setting 30
5.1.6 - Page - 8 - Output Jumper Switches