Filter
Top Products
®
LCD Display
The backlit LCD display of the DriveRack 260 provides the user with all of the vital processing
information of the DriveRack 260 including: signal routing, effect block editing and Wizard
Setup functions. The display will also notify the user if any internal clipping is taking place
within the unit by displaying “CLIP” in the display.
Data Wheel
The Data wheel of the DriveRack 260 is used to scroll through the program menu, load pro-
grams, select parameters and edit parameter values.
Function Buttons
The function buttons of the DriveRack 260 allow direct access to all editing and navigating func-
tions of the DriveRack 260. The functions of the aforementioned buttons are as follows:
<PREV PG> - is used to navigate back through the various pages of any module block.
<NEXT PG> - is used to navigate forward through the various pages of any module block.
<EQ> - is used to move to the EQ modules. Successive presses will move you through the
EQ modules in the input section and through EQ modules located in the output section.
<XOVER> - is used to move to the Crossover module.
<OTHER> - This button is used to move to the insert module section module which can
include modules such as: Notch Filters, Subharmonic Synthesizer and the
Advanced Feedback Suppression (AFS) modules.
<DYNAMICS> - is used to move to the Compressor, Compressor, Gate, Auto Gain Control
(AGC), or Limiter modules.
<DELAY> - is used to move to the Delay modules.
<I/O> - is used to move to select each one of the 2 input and 6 output modules.
<PROGRAM> (CONFIG)- is used to enter program mode. When pressed and held, the 260
will enter configuration mode.
<UTILITY> (METER)- is used to access the the Utility menu. When pressed and held, the
260 will enter METER mode.
<STORE> (DELETE)- is used to store any program changes. When pressed and held, the
260 will enter the PROGRAM DELETE module.
<RTA> (WIZARD)- is used to enter the RTA module. When pressed and held, the 260 will
enter the Wizard section which includes: SYSTEM SETUP, AFS and AUTO EQ WIZARD.
Input Meters
The DriveRack 260 provides the user with two independent, six segment Lightpipe™ input
meters that range from -30 to +22 dBu. These meters monitor the signal level right after the
input module.
Threshold Meters
The threshold meters indicate that the threshold level has been exceeded within the Limiter and
Auto Gain Control sections, and gain reduction may be taking place within the specific output
channel.
Output Mutes
The six output mute buttons are used for independently muting each output on all six outputs
of the DriveRack 260.
Getting Started
Section 1
DriveRack
™
DriveRack™ User Manual
3