Filter
Top Products
Ta b le of Contents
DriveRack
™
Introduction
0.1 Defining the 260 DriveRack ............................ii
0.2 Service Contact Info........................................iii
0.3 Warranty...........................................................iv
Section 1 - Getting Started
1.1 Rear Panel Connections...................................2
1.2 Front Panel .......................................................2
1.3 Quick Start........................................................4
Section 2 - Editing Functions
2.1 Basic Navigation Modes.................................14
2.2 Effect Button Array Overview .......................14
2.3 Navigating the Pre-EQ Section ......................15
2.4 Navigating the Crossover Section..................15
2.5 Navigating the Other Section ........................16
2.6 Navigating the Dynamics Section..................16
2.7 Navigating the Delay Section ........................17
2.8 Navigating the Utility/Meters Section............17
2.9 Navigating the Wizard Section ......................18
2.10 Navigating the I/O Section ..........................18
Section 3 - Configuration Functions
3.1 Program Definition.........................................20
3.2 Navigating Factory Programs.........................20
3.3 Editing Factory Programs...............................21
3.4 Saving Factory Program Changes..................22
3.5 Creating a User Configuration.......................23
3.6 Saving Configuration Changes.......................26
Section 4 - Detailed Parameters
4.1 Pre-Crossover EQ (31 Band Graphic) or
(9-Band Parametric)........................................28
4.2 Feedback Eliminator (AFS) ............................29
4.3 Subharmonic Synthesizer...............................30
4.4 Noise Gate ......................................................31
4.5 Automatic Gain Control (AGC) .....................32
4.6 Notch Filters....................................................33
4.7 Crossover ........................................................33
4.8 Post-Crossover PEQ........................................33
4.9 Compressor/Limiter........................................34
4.10 Alignment Delay...........................................37
4.11 Input Routing................................................37
4.12 Output...........................................................38
Section 5 - Utilities/Meters
5.1.1 LCD Contrast/Auto EQ Plot........................40
5.1.2 PUP Program/Mute......................................40
5.1.3 ZC Setup ......................................................41
5.1.4 Security.........................................................42
5.1.5 Program List/Program change ....................45
5.1.6 Output Jumper switches .............................46
5.2.1 Meters...........................................................47
Section 6 - Remote Control
6.1.1 PC GUI Installation......................................50
System Requirements ...........................................50
Install.....................................................................50
Basic Operation ....................................................50
Cable specs ...........................................................52
6.2.1 ZC-Zone Controllers....................................53
Section 7 - Application Guide
7.1 Mono 4-Way w/ 2 Aux Zones.......................58
7.2 Stereo Tri-Amp ...............................................59
7.3 Stereo w/ 4 Aux Zones..................................60
7.4 Stereo Bi-Amp w/ Dual Delays.....................61
Appendix
A.1 Factory Reset..................................................64
A.2 Power up Quick Key Options ......................64
A.3 Specifications..................................................65
A.4 Auto EQ Optimization...................................66
A.5 Crossover Diagrams.......................................67
A.6 Prog List/Speaker Tunings/
Power Amp Tunings......................................68
A.7 Block Diagram ...............................................69
A.8 Input and Output Section Diagrams ............70
A.9 Gain Level Jumpers .......................................71
A.10 System Setup and Gain Structure ...............71
®
DriveRack™ User Manual
Table of Contents