Filter
Top Products
®
Utilities/Meters
Section 5
DriveRack
™
41
®
DriveRack™ User Manual
Current: After cycling the power (or power failure), the unit will automatical-
ly reload a configuration exactly as it was prior to powering down. This
includes any adjustments made to any effect modules including: delays, EQs...
etc.
You also have the option of changing the set up so that when the DriveRack™ units are pow-
ered up, the output mutes will either power up all muted, or as they were set prior to the unit
shutting down. To change the PUP Mute setup, use the following procedure.
• From Program mode, press the UTILITY button and use the PREV PG and
NEXT PG button to move to the page that appears as follows:
• Select the PUP Mute adjustment by pressing the DATA wheel until the PUP
mute is selected. Once the PUP Mute has been selected, proceed to rotate
the DATA wheel until the desired mute setting (All, Saved ) is All= All out-
puts muted on powerup, Current= Outputs mutes on previous power down.
To exit, press the PROGRAM/CONFIG button.
A unique feature of the 260 DriveRack is its ability to interface with dbx proprietary Zone
Controller wall-panel switches. This feature gives you the ability to control various parameters
of the 260 such as Boost and Cut Program Changes and Switch closure changes.
• From Program mode, press the UTILITY button and use the PREV PG and
NEXT PG button to move to the page that appears as follows:
• Rotate the DATA wheel to select panels 1-6. Once the panel to edit has
been selected, press the STORE button to edit and the display give you the
option of selecting either ZC-1 (volume boost and cut), ZC-2 (volume boost,
cut and mute), ZC-4 (four assignable program change presets) and ZC-4
(Switch closure) by rotating the DATA wheel. If ZC-1 or 2 are selected, the
display will appear something like this:
ZC Setup
Panel 1 None
(STORE) - EDIT PANEL
5.1.3 -Page 3 - ZC Setup
Power Up Modes
PUP Program Stored
PUP Mute Current