Filter
Top Products
Preferences
This command opens the Preferences Dialog (shown below) where you can change various printing,
measurement and display settings
Plots can be switched between fine and bold lines separately for display and printing. You can select
metric units separately for Volumes and other units. Auto Ranging is normally on but can be switched
off for those occasions where you need a different fixed scale for repeat measurements. An initial
"connect the driver" dialog can be enabled for production testing. A preference can be set to measure
L(e) at either 1 kHz or 10 kHz. Measurement at 1 kHz is recommended for general use except when
measuring inductors less than 0.5 mH or drivers smaller than 6 inches in diameter where measurement
at 10 kHz is likely to be more representative.