Filter
Top Products
14
ENGLISH
Rear Panel
1 Tape Input
Connect the analog outputs of any recording device (analog tape recorder,
digital tape recorder, CD recorder, etc.) you may have to these single-
ended
RCA
connectors. You may select to hear the output of your
RCA connectors. You may select to hear the output of your RCA
recording device by touching the
tape
button on the main operational
screen of the CP-700.
2 Single-ended (RCA) inputs
These RCA jacks accept right-channel and left-channel (single-ended)
inputs from line-level source equipment such as tuners, CD players,
and tape decks. Any of these inputs may be selected by touching the
corresponding button on the main operational screen of the front panel
touchscreen.
To achieve the best possible results, we suggest that you use only high-
quality, shielded interconnect cables. Please consult with your local Classé
dealer for advice on the best cables for use in your system.
optional phono preamp
If you have a turntable you would like to use with the system, an optional
phono preampli–er module is available from your Classé dealer. Once
installed in your preampli–er, the
Line 1
input connectors become your
phono
inputs, and the
phono gain
control in the menu system becomes
active, allowing you to select either
low gain
for all moving-magnet (MM)
low gain for all moving-magnet (MM) low gain
and high-output moving-coil (MC) cartridges, or
high gain
for standard
high gain for standard high gain
output MC cartridges. (See the section
The Menu System
for more
The Menu System for more The Menu System
information.)
3 Balanced (XLR) inputs
These
XLR
jacks accept right-channel and left-channel balanced signals
XLR jacks accept right-channel and left-channel balanced signals XLR
from source equipment with balanced outputs. Either of these inputs may
be selected by touching the corresponding button on the main operational
screen of the LCD touchscreen.