Filter
Top Products
12
ENGLISH
2 Menu button
Pressing the front panel
Menu
button will call up the
main menu system
,
replacing the normal operational menu and status display in the LCD
touchscreen.
3 LCD touchscreen
Much of your interaction with the CP-700 will be via the
LCD
touchscreen
(and the CP-700»s supplied remote control). It will usually
display the various
input selection
buttons you would use in day-to-day
operation, along with access to the tape button.
By pressing the
Menu
button, you can also call up the
menu system
of the
menu system of the menu system
CP-700, which gives you control over many of the operational details of
the preampli–er, including
system setup
options, various
system setup options, various system setup
display
options
display options display
(including the
language
in which the menu system itself displays), and
language in which the menu system itself displays), and language
several custom-installation capabilities that allow superior integration of
the CP-700 into complex systems.
For more information, see the section
The Menu System
later in this
The Menu System later in this The Menu System
manual.
4 Mute button
The front panel
Mute
button reduces the volume of the preampli–er to
zero at the touch of a button. Pressing the button a second time restores
the volume to its previous setting. The behavior of the mute can also be
customized. Setup information on this feature is available in the
Volume
Setup
section.
Setup section.Setup
However, if you increase the volume manually (using either the
volume
knob
or the
remote control
) while the
Mute
button is engaged, the mute
control will disengage and the volume will be set to zero. This approach
is a safety measure, to avoid situations in which the volume might be
adjusted up while muted, only to then have the system un-muted to an
unexpectedly high volume.
5 IR window
The
infrared
(IR)
infrared (IR) infrared
receiver
and
receiver and receiver
transmitter
are located behind this
transmitter are located behind this transmitter
window. Ordinarily, your Classé CP-700 must be able to ≈see∆ the
remote control from this window in order to respond to remote control
commands.
If your preampli–er will be located behind closed doors, or for any
other reason will not be able to ≈see∆ the remote control during normal
operation, you may use the rear panel
IR input
and
IR input and IR input
output
mini-jacks and
output mini-jacks and output
an
IR repeater system
to solve the problem. For more information about
IR repeater system to solve the problem. For more information about IR repeater system
using an infrared repeater system to route signals to and from the CP-700,
refer to the section
Rear Panel
later in this manual, or contact your local
Rear Panel later in this manual, or contact your local Rear Panel
Classé dealer.