Filter
Top Products
Quick Start
This Quick Start section is intended to assist you in getting the ProMatrix
unit up and running quickly so that you can become familiar with it.
Important: Do not place any objects directly on top of the unit.
Leave at least 2 inches of space above the unit to assure prop-
er ventilation. When locating the PM-3180, be sure to leave at
least 2 inches of space on the right side of the unit to allow for
fan exhaust.
Install Control Panel
The unit is shipped with the control panel disassembled from the chassis.
You have the option of attaching the control panel to the front panel or
mounting it in a convenient location and connecting it to the unit using the
25-foot telephone cable included. For longer cable runs, use accessory
RMPWMK3 for secure and attractive mounting of the front panel up to 250
feet from the main unit.
Warning: Use only the telephone cable supplied. Use of any
other cable may damage the unit.
To attach the control panel to the chas-
sis, position the panel as shown. Line up
the tabs on the control panel with the
slots on the chassis. Push in on the
grooved areas on each side of the plas-
tic panel and push the control panel onto
the chassis to engage the locking tabs.
To mount the control panel in a
remote location:
1. Install two wall anchors 4-inches apart and level in the desired
location. The screws should protrude 1/2”.
2. BE SURE THAT POWER IS OFF WHEN YOU INSTALL OR REMOVE
THE CONTROL PANEL. Plug one end of the 25-foot remote cable into
the jack on the bottom right corner of the control panel. Plug the other
end into the jack labeled REMOTE on the rear panel of the ProMatrix
unit.
3. Place the control panel keyhole slots over the protruding screw heads
and pull down slightly to secure the panel.
Note: The panel must be oriented vertically to ensure proper
cooling of the internal electronic components.
4
Tabs Slots
Fan Outlet
(PM-3180 only)
Do Not Block