Filter
Top Products
Programming
Inhibit
This function lets the installer inhibit the user’s ability to change the preset
volume and tone settings for a particular amplifier (Bass and Treble are
always inhibited together as Tones. Pressing BASS or TREB does the same
thing). Once set, the unit will not respond to commands from the front
panel or remote controller for this amplifier channel in the user mode.
1. Enter programming mode and press the NEXT or BACK buttons until
INHIBIT appears on the display.
2. Press ENT to enter the function.
3. Select an amp/channel by pressing one of the AMP buttons.
4. Press one of the control buttons
(VOL, BASS or TREB). The dis-
play shows the current amplifier
and the inhibit status for the
selected control. You should
hear program over the speakers.
5. In the illustration at right, VOL is
the selected control. Press the
NEXT or BACK buttons to toggle
between
VOL ON and VOL OFF. (ON means that the volume function inhibit is
on and no user volume control is available on AMP 1. Likewise for the
other functions.)
6. Press ENT to store the selection. The PROG LED will blink to indicate
that data was stored.
Note: Volume and tone inhibit status for each amplifier can be
performed at one time. Simply press one of the other buttons
(VOL, BASS or TREB) after completing Step 6 and continue as
before :
7. Once the Inhibit function has been set, press EXIT to return to the func-
tion menu. At this point you can exit the programming mode or press
NEXT or BACK to select another function.
A1/VOL OFF
32