Filter
Top Products
v
TABLE OF CONTENTS
INTRODUCTION
1 1.1 Before Making Connections
1 1.2 In-Use Notices
2 1.3 Front Panel
3 1.4 Rear Panel MRX 710
4 1.5 Rear Panel MRX 310
5 1.6 Remote Control
6 1.7 Speaker Positioning
CONNECTIONS
6 2.1 Video Connections
7 2.2 Audio Connections
10 2.3 Antennas
10 2.4 Local Area Network
10 2.5 12 Volt Trigger
10 2.6 Infra Red
10 2.7 Power
SETUP
13 3.1 HDMI Output Configuration
14 3.2 Speaker Setup
16 3.3 Bass Managment
17 3.4 Listener Position
18 3.5 Level Calibration
19 3.6 Input Setup
23 3.7 Volumes / Rec Output
24 3.8 Network / Remote Control
27 3.9 Display
28 3.10 General Configuration
30 3.11 Save / Load Settings
31 3.12 System Information
ANTHEM ROOM CORRECTION
33 4.1 Before Starting
33 4.2 ARC Software Installation
34 4.3 Microphone Stand Assembly
34 4.4 Microphone Positioning
34 4.5 Measurement
35 4.6 Manual Mode and Targets
36 4.7 Advanced Subwoofer Targets
37 4.8 Printing A Report
37 4.9 Updating ARC
OPERATION
38 5.1 Power On / Off and Volume
38 5.2 Zone 2 Operation
39 5.3 Input Selection
39 5.4 Tuner
40 5.5 Level Trim
41 5.6 Bass / Treble / Balance
41 5.7 Lip-Sync
41 5.8 Listening Modes
42 5.9 Dolby Volume and Dynamic Range Control
42 5.10 Display Brightness
42 5.11 Info Display
43 SPECIFICATIONS
44 LIMITED WARRANTY
45 THE BIG PICTURE: FRONT PANEL (MRX 710)
46 THE BIG PICTURE: REAR PANEL (MRX 710)
47 THE BIG PICTURE: REAR PANEL (MRX 310)