Filter
Top Products
25
IP CONFIGURATION
Settings in this submenu should only be changed if your network administrator gives the
direction or if using Direct Connect to run ARC.
MODE
Static IP settings take effect once this is changed to Manual. For ARC, enter the IP,
Subnet Mask, and Gateway values shown above (note that the receiver’s IP address is
not the same as the computer’s).
TRIGGER CONFIGURATION
When the receiver’s trigger output is connected to the trigger input of another
component, such as an amplifier or projector, the receiver can turn it on or off according
to the trigger’s setup.
In the example shown, the trigger activates while Main or Zone 2 power is turned on.
Trigger outputs can also be set to activate according to any combination of inputs
instead of Power.
If triggers are to be controlled through IP or RS-232, change “Menu” to “RS-232/IP”.
IP Configuration
Mode Auto
IP 192.168.1.3
Subnet Mask 255.255.255.0
Gateway 192.168.1.1
Trigger Configuration
Trigger Control Menu
Power Main or Zone 2
HDMI 1 Off
HDMI 2 Off
HDMI 3 Off
FM Off
AM Off