Filter
Top Products
10
2.3 ANTENNAS
To connect the AM loop antenna, press the spring-loaded tabs of the AM
ANTENNA connector and insert the bare ends of the two wires. Move the
antenna until best reception is found.
For the FM antenna, use the FM ANTENNA connector. Later, when unit is
operating move the antenna to find best reception.
2.4 LOCAL AREA NETWORK
This connection is required for configuring Anthem Room Correction and
for using IP control. Connect your router using CAT5 cable or a wireless
bridge. In the absence of a network or Ethernet router, ARC may also
be used with direct CAT5 connection to personal computer although this
requires configuring a static IP address.
2.5 12 VOLT TRIGGER
If another system component has a trigger input it can be activated by
the receiver. Connect the receiver’s trigger output using a cable with
3.5mm mini plugs. The receiver provides flexible trigger options. Through
the setup menu, you can specify the conditions for enabling triggers.
2.6 INFRA RED
An external IR receiver allows the remote control to be used from another
location in your home – connect the receiver from an external IR hub to the IR
IN jack. Most standard IR repeater kits can be used but to avoid problems test
compatibility before installing permanently.
IR OUT is provided for convenience. Through an IR emitter, commands
coming in through the rear panel IR IN can be re-transmitted to the IR sensor of
another component in your system.
2.7 POWER
Connect the power cord to the receiver and the
power source.