Filter
Top Products
36
6. REMOTE CONTROL OPERATION continued …
6.2 RECORD PATH SELECTION
• Make sure ‘personality’ is set to MAIN, press REC, then select Source within timeout period.
6.2.1 COPYING THE MAIN PATH TO ZONE2, ZONE3, OR RECORD
Select a MAIN Source first and for...
• ZONE2 or ZONE3: Make sure ‘personality’ is set to Z2 (or Z3), then press COPY.
• RECORD: Make sure ‘personality’ is set to MAIN, press REC, then press COPY.
Note: The only way to send digital inputs and 6-Ch S/E input to ZONE2, ZONE3, or RECORD is through
the Copy function (see sections 5.2.1 and 7.4.5).
6.3 SOURCE SELECTION
After selecting the desired Path (MAIN, ZONE2, ZONE3, or RECORD), press one of
ten Source keys in the SSP SOURCE group.
6.3.1 SOURCE SEEK (Remote Control Only)
The SOURCE SEEK keys provides an easy way to find the active Sources. The
keys go to the previous and next Source with a signal on it, while thekey
advances one Source at a time.
6.4 DIRECT FM • AM STATION ENTRY (Remote Control Only)
When using the FM • AM Tuner, the station frequency can be entered as a four-digit number. For
example, to tune into 98.3 FM, press and hold SELECT until the display shows “<blank>0.0” in
the lower left corner, then press 0, 9, 8, 3.
6.5 SLEEP TIMER (Remote Control Only)
If you would like to go sleep while listening to a program or music, the Sleep Timer will automatically turn the
AVM 30 power off after a preselected time. So when you find yourself falling asleep at the ‘tube’, take the
Remote Control and:
• Select the desired Path (MAIN, ZONE2, or ZONE3), then press SLEEP (the Sleep timer will
operate for that Path only).
• The first SLEEP keystroke always resets the timer to 30 minutes. Additional keystrokes then cycle
as follows: Second=60, third=90, fourth=Disabled.
• Once set, the time remaining appears as the number following ‘Zzz’ in the display.
6.6 ENABLE / DISABLE TIMERS (Remote Control Only)
To enable or disable all timers without entering the Setup, press and hold the
SLEEP key until the display shows ‘ALL TIMERS’, then use the keys to
enable/disable (see section 7.4.1).
REC
S
S
P
P
A
T
H
PIP
COPY
S
T
A
T
U
S
SELECT
S
T
A
T
U
S
SELECT
I
N
F
O
S
E
T
U
P
PIP SWAP MOVE
SSP SOURCE
COPY
AUX TAPE
DVD
TV
SAT
VCR
2-Ch
CD
REC
FM
AM
6-Ch
S
S
P
P
A
T
H
SOURCE SEEK
SLEEP
T
I
M
E
R
S