Filter
Top Products
To unplug the connector of the flat cable
Press the tabs and pull out.
For better FM reception, use of an outdoor antenna is
recommended,
Connect the outdoor antenna to FM 75 Q terminals.
p’ ‘“
To connect other optional equipment+ page 30.
Inserting batteries
Detach the battery cover on the rear of the remote control and
insert two R6 (size AA) batteries.
R6(AA)
When to replace the batteries
The maximum operational distance between the remote control
and the sensor on the main unit should be approximately 5 meters
(16 feet). When this distance decreases, replace the batteries
with new ones,
Using the remote control
The instructions in this manual refer mainly to the buttons on the
main unit. Buttons on the remote control with the same names
as those on the main unit can be used as well.
● If the remote control is not going to be used for an extended
period of time, remove the batteries to prevent possible
electrolyte leakage.
● The remote control may not operate correctly when:
- The line of sight between the remote control and the remote
sensor inside the display window is exposed to intense light,
such as direct sunlight
- Other remote controls are used nearby (those of a television,
etc.)
AOPEN/CLOSE
MULTI JOG
■STOP DEMO
I
DISPLAY
I
1 I
II
POWER
PHONES
TUNING
V,A
To
turn the power on
Press one of the function buttons (TAPE, TUNER, VIDEO/AUX,
CD, MD). Playback of the inserted disc or tape begins, or the
previously tuned station is received (Direct Play Function).
POWER is also available.
When the unit is turned on, the disc compartment may open and
close to reset the unit.
To
turn the power off
Press POWER.
Using the headphones
Connect headphones to the PHONES jack with a standard stereo
plug (06.3 mm,
‘/4 inch).
No sound is output from the speakers while the headphones are
plugged in.
Flash window
The window on the top of the CD player lights up or flashes
while the unit is being powered on.
To turn off, press
■ STOP of the CD player while pressing
AOpEN/CLOSE. To turn back on, repeat the above.
To
dim the illumination of the display
1
Press DISPLAY twice so that “DIMMER” is displayed.
2 Within 4 seconds, turn MULTI JOG to select the dimmer mode
as follows.
r
DIMMER O* DIMMER 1 * DIMMER 2
7
DIMMER O: The normal display.
DIMMER 1: The illumination of the display is dimmer than
usual.
DIMMER 2: The illumination of the display is dimmer than
DIMMER 1, and the spectrum analyzer and
illumination on the buttons disappear.
To
change the spectrum analyzer display
4 patterns of spectrum analyzer display can be shown.
Press DISPLAY once, and turn MULTI JOG within 4 seconds to
select the desired spectrum analyzer display.
(a EAIGL/SH