Filter
Top Products
1 2,3 1,2J3
1
2
3
Press CLOCWTIMER m, then
within 6 seconds.
press ENTER
Turn MULTI JOG to designate the hour, then press
ENTER.
The hour stops flashing and the minute starts flashing.
Turn MULTI
JOG to designate the minute, then
press ENTER.
The minute stops flashing on the display and the clock starts
from 00 seconds.
To switch to the 24-hour standard
Press the CLOCWTIMER and then press MULTI JOG within 6
seconds.
Repeat the same procedure to restore the 12-hour standard.
If the clock display flashes
This is caused by a power interruption. The current time needs
to be reset.
If power is interrupted for more than approximately 24 hours,
all settings stored in memory after purchase need to be reset.
● CLOCK on the remote control is also available instead of CLOCK7
TIMER.
● IISET on the remote control is also available instead of ENTER.
● 44 or W on the remote control is also available instead of MULTI
JOG.
‘?5
The unit can be turned off automatically at a specified time.
Use the remote control.
1
2
Press SLEEP.
“SL~EP” appears.
Within 4 seconds, press ++ or * to specify
the time until the power is turned off.
Each time the button is pressed, the time changes between 5
and 240 minutes in 5-minute steps.
To check the time remaining until the power is turned off
Press SLEEP W. The remaining time is displayed for 4
seconds.
To cancel the sleep timer
Em
Press SLEEP ME so that “SLEEP on the display disappears.
ENGLISIY 13