If the unit fails to perform as described in these Operating
Instructions, check the following guide.
GENERAL
There is no sound.
● Is the AC cord connected properly?
● Is there a bad connection? (+ page 4)
● There may be a short circuit in the speaker terminals.
~+ Disconnect the AC cord, then correct the speaker
connections.
● Was an incorrect function button pressed?
Sound is emitted from one speaker only.
● Is the other speaker disconnected?
The output sound is not stereo.
● Is the Karaoke function turned on? (+ page 19)
An erroneous display or a malfunction occurs.
+
Reset the unit. See “To reset”.
STEREO RECEIVER
There is constant, wave-like static.
● Is the antenna connected properly? (+ page 5)
● Is the signal weak?
+ Connect an outdoor antenna.
The reception contains noise interferences or the sound
is distorted.
● Is the system picking up external noise or multipath distortion?
* Change the orientation of the antenna.
+
Move the unit away from other electrical appliances.
CASSETTE DECK
The tape does not run.
c ISdeck
in pause mode? (+ page 25)
The sound is off-balance or not adequately high.
● Is the playback head dirty? (~ page 31)
Recording is not possible.
● Is the erasure prevention tab on the tape broken off? (+ page
26)
● Is the recording head dirty? (+ page 31)
Erasure is not possible.
● Is the erasure head dirty? (+ page 31)
● Is a metal tape being used?
High frequency sound is not emitted.
● 1sthe recording/playback head dirty? (+ page 31)
● Is a tape recorded without Dolby NR played back with the Dolby
NR system operating? (+ page 25)
To reset
If an unusual condition occurs in the display windows or the
cassette decks, reset the unit as follows.
1 Press POWER to turn off the power.
2 Press
POWER to turn the power back on while pressing
SET. Everything stored in memory after purchase is
canceled.
If the power cannot be turned off in step 1 because of a
malfunction, disconnect the AC cord. Then connect it again
and carry out step 2.
POWER
I
SET
Stereo receiver
CD PLAYER
The CD player does not play.
● Is the disc correctly placed? (+ page 20)
● Is the disc dirty? (+ page 31)
● Is the lens affected by condensation?
+ Wait approximately one hour and try again.
32 ENGLISH