Filter
Top Products
1-8
Getting Started
Step 3. Connect the Line-Power Cable
Step 3. Connect the Line-Power Cable
CAUTION
Always use the three-prong AC power cord supplied with this instrument.
Failure to ensure adequate earth grounding by not using this cord may cause
instrument damage.
CAUTION
Do
not
connect ac power until you have verified the line voltage is correct as
described in the following paragraphs. Damage to the equipment could result.
CAUTION
This instrument has autoranging line voltage input. Be sure the supply voltage
is within the specified range.
1
Verify that the line power meets the requirements shown in the following table.
2
Connect the line-power cord to the instrument’s rear-panel connector.
Line Power Requirements
Power 115 VAC: 50 WATTS MAX
230 VAC: 50 WATTS MAX
Voltage nominal: 115 VAC range:90–132 V
nominal:230 VACrange:98–254 V
Frequency nominal: 50 Hz/60 Hzrange: 47–63 Hz