122
Troubleshooting
Appendix
a) Displayed only when setup menu item 016 ALARM DISPLAY is set to
“on”.
Alarms relating to sensors and drives
Alarms related to system frequency
REF NON-STD A NON-STANDARD REF SIGNAL IS
BEING USED FOR REF VIDEO. USE A
STANDARD SIGNAL.
Input a standard signal.
Alarm message in time
data display area
Alarm message in video monitor screen Action
Alarm message in time
data display area
Alarm message in video monitor acreen Description/action
FAN Stopped FAN MOTOR STOPPED. Contact a Sony service representative.
Note
The unit will not stop operating, but if you continue to
use it in this state temperatures inside the unit or the
drive will rise, possibly resulting in failure or fire.
DR-FAN Stop DRIVE FAN MOTOR STOPPED.
N-FAN Stop FAN MOTOR ON NET-4 BOARD
STOPPED.
High TEMP! HIGH TEMPERATURE.
HIGH TEMPERATURE IN DRIVE.
HIGH TEMPERATURE ON NET-4 BOARD.
HUMID! MOISTURE HAS BEEN DETECTED. Stop recording or playback, power the unit off and on
again, and wait until the HUMID display disappears.
BATT EMPTY! BATTERY EMPTY! Change the battery.
Unknown USB UNKNOWN USB DEVICE. The USB connector of this unit is for maintenance
purposes only. Do not connect a USB device for any
purpose other than maintenance.
Alarm message in time
data display area
Alarm message in video monitor screen Action
1080/59.94i RECORDING AND PLAYBACK IS NOT
POSSIBLE.SYSTEM FREQUENCY
SELECTION DIFFER FROM IT ON DISC.
This appears when the system frequency selection of
the unit differs from that of the loaded disc.Insert a
disc with the same system frequency as the unit, or
change the unit's system frequency.
1080/50i
