106
Setup Menu
Chapter 7 Menus
Extended menu operations
The extended menu can be used with the same procedures
as in the basic menu.
However, since with the factory default settings the
extended menu is not displayed, it is first necessary to
enable display of the extended menu.
To enable display of the extended menu
Proceed as follows to use the maintenance menu.
1
Holding down the PAGE/HOME button and the
SHIFT button, press the MENU button.
The maintenance menu appears on the video monitor
display.
Menu items in the 900s, relating to digital process
Item number Item name Settings
920 SD-SDI H-ANC CONTROL Select whether to add information to the SDI output.
Sub-item
1 AUDIO 5CH-8CH off: Do not add digital audio data channels 5 to 8.
on
: Add digital audio data channels 5 to 8.
2RP188 ATC off: Do not add RP188 timecode data.
on
: Add RP188 timecode data.
930 DOWN CONVERTER MODE (DC) Select the down-converter mode.
CROP (EDGE CROP)
: Select the edge-crop mode.
L-BOX (LETTER BOX): Select the letter box mode.
SQUEZ (SQUEEZE): Select the squeeze mode.
931 DOWN CONVERTER LETTER BOX
MODE (DC)
Select the aspect ratio of the down-converter output when menu item
930 is set to “l-box”.
16:9
: Set the aspect ratio of the HD-SD converter output to 16:9.
14:9: Set the aspect ratio of the HD-SD converter output to 14:9.
13:9: Set the aspect ratio of the HD-SD converter output to 13:9.
932 H CROP POSITION (DC) Adjust the H-crop (the horizontal position when cropping in the edge crop
mode) of the down converter output when menu item 930 is set to “crop”.
–120 to 0
to 120
934 CROSS COLOR (DC) Adjust the down-converter cross color.
0 to 8
to 15
935 DETAIL GAIN (DC) Adjust the down-converter image enhancer, the sharpness of edge
emphasis.
0
to 7FH
936 LIMITER (DC) Adjust the down-converter image enhancer, the maximum detail level
added to emphasize the original signal.
0 to 20H
to 3FH
937 CRISP THRESHOLD (DC) Adjust the down-converter image enhancer, the threshold amplitude at
which low amplitude signals are not emphasized.
0
to FH
938 LEVEL DEPEND THRESHOLD
(DC)
Adjust the down-converter image enhancer. Set the luminance range for
edge enhancement.
0 to 8
to FH
939 H DETAIL FREQUENCY (DC) Adjust the down-converter image enhancer. Set the central frequency for
edge enhancement.
2.6MHz, 3.4MHz, 3.9MHz
, 4.6MHz
940 H/V RATIO (DC) Adjust the down-converter image enhancer. Set the horizontal/vertical
ratio for edge enhancement.
0 to 3
to 7
942 V FILTER SELECT Set the vertical interpolation filter coefficient for down-converter output.
1
to 3
943 CROSS COLOR CRISP Set the cross color crisp level for down-converter output.
0 to 4
to FH
