104
Setup Menu
Chapter 7 Menus
743 PR LEVEL (HD) Adjust the PR level of the high-definition video signal output from the
HDSDI OUTPUT 1, 2 (SUPER) connectors.
–2048 to 0
to 846
745 SETUP LEVEL (HD) Adjust the setup level of the high-definition video signal output from the
HDSDI OUTPUT 1, 2 (SUPER) connectors.
–272 to 0
to 272
746 SYNC PHASE (HD) Control the H sync phase of the high-definition video signal output from
the HDSDI OUTPUT 1, 2 (SUPER) connectors.
–128 to 0
to 127
747 FINE (HD) Fine control the H sync phase of the high-definition video signal output
from the HDSDI OUTPUT 1, 2 (SUPER) connectors.
0
to 1023
Menu items in the 800s, relating to audio control
Item number Item name Settings
802 DIGITAL AUDIO MUTING IN
SHUTTLE MODE
Set the audio muting conditions during shuttle playback.
off
: Not muted.
on: Muted.
807 AUDIO OUTPUT PHASE Set the output timing of digital audio playback signals (HDSDI, SDI, AES/
EBU only), with 80H as a reference position. Output timing is earlier for
values smaller than 80H and later for values greater than 80H. (80H, 128
samples = approx. 2.7 ms, 80H, 1 sample = approx. 20 μs)
0 (0 (HEX))... 80 (80 (HEX))
... FF (FF (HEX)): Values can be set in this
range.
808 INTERNAL AUDIO SIGNAL
GENERATOR
Select the operation of the internal audio test signal generator.
silnc (silence): Silent signal.
1kHz (1kHz sine)
: 1 kHz, –20 dB FS sine wave signal.
When you select SG as the audio input in the input selection section of
the control panel, the audio test signal generated by the internal audio
test signal generator is input.
815 AUDIO SAMPLING RATE
CONVERTER
Select the mode of operation of the sampling rate converter for AES/
EBU input to channels 1 to 4.
off
: Do not operate.
on: Operate.
823 NON-AUDIO FLAG PB Control non-audio flags in digital audio output.
Sub-item
1 CH1/CH2 During playback (except E-E mode), set non-audio flags in digital audio
output to the following states.
on: Set to on (data is non-audio.)
auto
: Set as follows.
• When data is read from disc and confirmed: Follow the data.
• When data from disc is not confirmed: Maintain current state.
2 CH3/CH4
3 CH5/CH6
4 CH7/CH8
824 ANALOG LINE OUTPUT SELECT Select the analog audio signals (tracks 1 to 8) to be assigned to audio
output channels 1 and 2.
tr1/2
: Tracks 1 and 2 assigned to audio output channels 1 and 2.
tr3/4: Tracks 3 and 4 assigned to audio output channels 1 and 2.
tr5/6: Tracks 5 and 6 assigned to audio output channels 1 and 2.
tr7/8: Tracks 7 and 8 assigned to audio output channels 1 and 2.
Menu items in the 700s, relating to video control
Item number Item name Settings
