Aileron differential is used to correct roll to yaw
coupling and adverse yaw characteristics. In order to
activate differential, the flaperon wing type must have
been selected in the system mode (see Section 6.4).
Also, each aileron control surface must have its own
servo with the right aileron servo plugged into the
aileron channel (#2) on the receiver and the left
aileron servo plugged into the Flap Aux 1 channel (#6)
on the receiver.
1. Turn on the transmitter.
2. Flaperon wing type must be selected
(see Section 6.4).
3. Press the SCROLL and INCREASE buttons
simultaneously to enter the function mode.
4. Press the SCROLL button until “MIX DIF”
appears on the screen.
5. Press the INCREASE or DECREASE button to
adjust the differential mixing value.
6. Press the SCROLL button to access the flap-
to-elevator offset trim function.
7. To exit, press the SCROLL and INCREASE
buttons simultaneously.
DIFFERENTIAL
7.8
CHAPTER 7: FUNCTIONS (FUNCTION MODE)
•
Airplane
Press the SCROLL button until
“MIX DIF”appears on the screen.
Press the INCREASE or DECREASE
button to adjust the differential value.
