Filter
Top Products
62
ZONE 2
SOURCE
SELECT
SYSTEM
POWER
STANDBY
PHONO
V-AUX TUNER MD/TAPE CD-R CD
D-TV/LD CBL/SAT VCR 1 VCR 2/DVR DVD
10KEY DSP HALL 1 HALL 2 CHURCH JAZZ CLUB
ROCK
CONCERT STADIUM
TV
SPORTS
ENTER-
TAINMENT
6.1/ES
MONO
MOVIE
MOVIE
THEATER 2
MOVIE
THEATER 1
/DTS
SUR.
0 +10 +100
1234
5678
9101112
++
TV VOL
A / B / C / D / E PRESET
TV INPUT
TV MUTE
CH
DISC
CHP/INDEX
––
TITLE
ENTER
MENU
SOUND
DISPLAY
SEARCH CHAPTER
POWER REC STOP PAUSE PLAY
+–
/
6CH INPUT
SOURCE
SELECT
+
MUTE
EFFECT
VOLUME
–
6CH INPUT
TITLE
ENTER
MENU
SOUND
DISPLAY
SOURCE
SELECT
SEARCH CHAPTER
POWER REC STOP PAUSE PLAY
+–
/
6CH INPUT
TITLE
ENTER
MENU
SOUND
DISPLAY
SOURCE
SELECT
SEARCH CHAPTER
POWER REC STOP PAUSE PLAY
+–
/
SOURCE
SELECT
LEARN
■ Special considerations when
using DTS software
The DTS signal is a digital bitstream. Therefore, if you
attempt to send the DTS signal to the second room, you
will only be able to hear the digital noise sound that could
damage your speakers.
Due to this characteristic of DTS encoded discs, the
following considerations and adjustments need to be
made.
For LDs or DVDs encoded with DTS
Only 2-channel analog audio signals may be sent to the
second room, as follows:
• LDs
Set your LD player’s left and right outputs to the
analog soundtrack.
• DVDs
Use the disc menu to set the DVD player’s mixed 2-
channel left and right audio outputs to the PCM or
Dolby Digital soundtrack.
For CDs encoded with DTS
DO NOT USE the Zone 2 feature for CDs encoded with
DTS.
Remote Control in Zone 2
In the second room (Zone 2), the supplied remote control
can be used for the Zone 2 remote control. You can select
the input source and control the component which is
located in the main room directly from the second room
regardless of the listening condition in the main room.
Before starting the following procedure, set REC OUT/
ZONE 2 on the front panel to SOURCE/REMOTE.
1 Repeat steps 1 and 2 of the procedure in
“Setting the Manufacturer Code” on page 54.
2 Press l / h to select “L:AMP”.
3 Press k / n to select “Zone2”.
4 Press LEARN to complete the Zone 2 setup.
5 Press SOURCE SELECT k to display
“Zone2” in the display window.
6 Press an input selector button to select the
input source you want to listen to in the
second room.
The display window shows “2: name of selected
input” if the remote control is in the Zone 2 mode.
7 You can control the component by using the
component control area buttons.
Note
• Adjust the Zone 2 volume with the control on the amplifier in
the second room.
8 Press SOURCE SELECT k / n to exit from
the Zone 2 mode.
0109V1000_54-62_EN 8/29/0, 1:28 PM62