Filter
Top Products
55
EnglishINTRODUCTION PREPARATION
BASIC OPERA-
TION
ADVANCED
OPERATION
ADDITIONAL
INFORMATION
APPENDIX
REMOTE CONTROL FEATURES
■ Controlling a different
component from the source
component (input) you have
selected
1 Repeat steps 1 and 2 of the procedure in
“Setting the Manufacturer Code”.
2 Press l / h to select a library (component
category).
There are 13 libraries to set up a manufacturer code:
L:TV, L:CAB (CABLE), L:DBS, L:SAT, L:VCR,
L:DVD, L:LD, L:CD, L:CDR, L:MD, L:TAP (TAPE),
L:TUN (TUNER) and *L:AMP.
3 Repeat steps 3 and 4 of the procedure in
“Setting the Manufacturer Code”.
About amplifier libraries (L:AMP)
L:AMP has 4 codes: YPC, Zone2, DSP, and No.
“YPC” or “Zone2” should be selected to operate this
unit. “DSP” is for operating YAMAHA DSP amplifiers
other than this unit. “No” is to clear this unit control
area functions.
Note
• “YPC” is factory-set as the amplifier library. When you
make up a second audio-video room with this unit’s Zone 2
feature, you must set “Zone2” as the amplifier library in the
remote control (see page 62 for details).
6CH INPUT
TITLE
ENTER
MENU
SOUND
DISPLAY
SOURCE
SELECT
SEARCH CHAPTER
POWER REC STOP PAUSE PLAY
+–
/
TRANSMITRE-NAME CLEAR
MACRO
MACROLEARN
OFFON
SYSTEM
POWER
STANDBY
PHONO
V-AUX TUNER MD/TAPE CD-R CD
D-TV/LD CBL/SAT VCR 1 VCR 2/DVR DVD
6CH INPUT
TITLE
ENTER
SYSTEM
POWER
STANDBY
PHONO
V-AUX TUNER MD/TAPE CD-R CD
D-TV/LD CBL/SAT VCR 1 VCR 2/DVR DVD
10KEY DSP
Programming a New Remote
Control Function (Learn Feature)
If you want to program functions not included in the basic
operations covered by the manufacturer code, or a
manufacturer code is not available, the following
procedure needs to be performed. The possible
programming area is the same as a component control
area, so the buttons are programmable independently for
each source component area.
Note
• This remote control transmits infrared rays. If the other remote
control also uses infrared rays, this remote control can learn
most of the other remote control’s functions. However, you
may not be able to program some special signals or extremely
long transmissions. (Refer to the operation instructions for the
other remote control.)
1 Set 10KEY/DSP to 10KEY.
2 Press an input selector button, A or B to
select a source component.
3 Place this remote control and the other
remote control about 50 to 100 mm (2 to
4 in.) apart on a flat surface so that their
infrared transmitters are aimed at each other.
about 50 to 100 mm
(2 to 4 in.)
0109V1000_54-62_EN 8/29/0, 1:26 PM55