Filter
Top Products
45
EnglishINTRODUCTION PREPARATION
BASIC OPERA-
TION
ADVANCED
OPERATION
ADDITIONAL
INFORMATION
APPENDIX
3 Press –/+ to adjust the speaker output level.
• The control range for the center, left and right rear
or rear center speakers is from +10 dB to –10 dB.
• The control range for the subwoofer is from 0 dB
to –20 dB.
y
• When PARAMETER/SET MENU is set to SET MENU, you
cannot adjust the output level by using LEVEL. However, each
time you press LEVEL, the current level of each speaker
appears on the front panel display and you can check the
speaker level.
Notes
• If the speaker output mode is set to NONE, the output level of
that speaker cannot be adjusted.
• When you adjust the output level with LEVEL, the settings you
made with the test tone will be changed.
Memory back-up
The memory back-up circuit prevents the stored data
from being lost even if this unit is set in the standby
mode, the power cord is disconnected from the AC
outlet, or the power supply is temporarily cut due to
power failure. However, if the power is cut for more
than one week, the output level of the effect speakers
you adjusted will return to the factory settings. If so,
adjust the output level again.
ADJUSTING THE LEVEL OF THE EFFECT SPEAKERS
PARAMETER
SET MENU
LEVEL
You can adjust the output level of each effect speaker
(center, left and right rear, rear center (see page 17) and
subwoofer) while listening to a music source.
Adjustment should be made with the remote control.
1 Set PARAMETER/SET
MENU to PARAMETER.
2 Press LEVEL repeatedly to select the
speaker(s) you want to adjust.
Each time you press LEVEL, the selected speaker
changes and appears on the front panel display and
on the video monitor as follows: center, right rear,
rear center (see page 17), left rear and subwoofer.
ON SCREEN
LEVEL
SLEEP TEST
PARAMETER
SET MENU
3
2
1
LEVEL
Center speaker output level
Right rear speaker output
level
Rear center speaker output
level
Left rear speaker output
level
Subwoofer output level
y
• Once you press LEVEL, you can also select the speaker(s) to
be adjusted by pressing n. (Pressing k changes the selection in
the reverse order.)
0107V1000_36-46_EN 8/29/0, 1:35 PM45