Filter
Top Products
23
EnglishINTRODUCTION PREPARATION
BASIC OPERA-
TION
ADVANCED
OPERATION
ADDITIONAL
INFORMATION
APPENDIX
ADJUSTING THE SPEAKER OUTPUT LEVELS
TEST
+
VOLUME
–
LEFT SURROUND
(TEST L SUR.)
RIGHT SURROUND
(TEST R SUR.)
CENTER
(TEST CENTER)
REAR CENTER
(TEST R CENTER)
RIGHT
(TEST RIGHT)
LEFT
(TEST LEFT)
Using the Test Tone (TEST DOLBY
SUR.)
Use the test tone to balance the output levels of the
6 speakers required for a surround sound system. The
adjustment of each speaker output level should be made
at your listening position with the remote control. After
completing the adjustments, use VOLUME +/– at your
listening position to check if the adjustments are
satisfactory.
1 Press TEST to output the test tone.
2 Adjust the volume so you can hear the test
tone.
The test tone is heard from the left main speaker,
center speaker, right main speaker, right rear speaker,
rear center speaker (see page 17) and left rear
speaker in order. The tone is produced for
2.5 seconds each time.
++ +
TV VOL
A / B / C / D / E
PRESET
TV INPUT
TV MUTE
CH
DISC
MUTE
EFFECT
VOLUME
–– –
ON SCREEN
LEVEL
SLEEP TEST
PARAMETER
SET MENU
1,5
3
4
2
The state of the test tone output is also shown on the
monitor by an image of the audio listening room.
This is convenient for adjusting each speaker level.
y
• If “1A CENTER SP” on the SET MENU is set to NONE, the
center channel sound is automatically output from the left and
right main speakers.
Note
• If the test tone cannot be heard, turn down the volume, set the
unit in the standby mode and check the speaker connections.
3 Press k / n repeatedly to
select the speaker to be
adjusted.
y
• You can stop the sequence temporarily by holding down k / n.
4 Press –/+ repeatedly to
adjust the output level of
the effect speakers so that
the output level coming
from each speaker is the
same.
While adjusting, the test tone is heard from the
selected speaker.
5 When the adjustment is complete, press
TEST.
The test tone stops and the
current DSP program appears
on the front panel display and
on the video monitor.
y
• The tonal quality of the center speaker can be adjusted by using
“5 CENTER GEQ” on the SET MENU (see page 41).
• You can increase the output levels of the effect speakers
(center, left rear, right rear and rear center) to +10 dB. If the
output level of these speakers is lower than that of the main
speakers even after you have increased the output level of these
speakers up to +10 dB, set “1F MAIN LEVEL” on the SET
MENU to –10 dB (see page 40). This setting decreases the
main speaker output level to about one-third of the normal
level. After you have set “1F MAIN LEVEL” on the SET
MENU to –10 dB, adjust the levels for the center, rear and rear
center speakers again.
TEST
TEST DOLBY SUR.
LEFT
0104V1000_19-23_EN 8/29/0, 1:33 PM23