Filter
Top Products
61
EnglishINTRODUCTION PREPARATION
BASIC OPERA-
TION
ADVANCED
OPERATION
ADDITIONAL
INFORMATION
APPENDIX
OUT IN OUT IN
REMOTE
CONTROL OUT
REMOTE CONTROL OUT REMOTE CONTROL IN
ZONE 2 VIDEO OUT
ZONE 2 AUDIO OUT
ZONE 2
You can make up a multi-room audio-video system with this unit. This feature enables you to set this unit to reproduce
separate input sources in the main room and second room (Zone 2) with the supplied remote control in the second room.
Only analog signals are sent to the second room. For any source you want to listen to in the second room, you must
connect the analog output jack from the source to the corresponding analog input jack on this unit.
Zone 2 Connections
To use the multi-room functions of this unit, you need the following additional equipment:
• An infrared signal receiver in the second room
• An infrared emitter in the main room
This emitter transmits the infrared signals from the remote control in the second room to the main room
(for example, to a CD player or LD player).
• An amplifier and speakers for the second room
• A video monitor for the second room
y
• Since there are so many ways to connect and use this unit in a
multi-room installation, we recommend that you consult with
the nearest authorized YAMAHA dealer or service center for the
Zone 2 connections which will best meet your requirements.
• Some YAMAHA models are able to connect directly to the
REMOTE CONTROL OUT jack of this unit. If you own these
products, you may not need to use an infrared emitter. Up to 6
YAMAHA components can be connected as shown.
This unit
■ Example of a system configuration and connections
Main room
DVD player
(or other component)
This unit
Infrared emitter
Second room
Amplifier
Video
monitor
Remote control
(in the Zone 2 mode)
Infrared signal receiver
0109V1000_54-62_EN 8/29/0, 1:27 PM61