Filter
Top Products
28
CONNECTIONS
Both FM and AM indoor antennas are supplied with this
unit. In general, these antennas should provide sufficient
signal strength. Connect each antenna correctly to the
designated terminals.
• The AM loop antenna should be placed away from this unit.
• The AM loop antenna should always be connected, even if an
outdoor AM antenna is connected to this unit.
• A properly installed outdoor antenna provides clearer reception
than an indoor one. If you experience poor reception quality,
install an outdoor antenna. Consult the nearest authorized
YAMAHA dealer or service center about outdoor antennas.
■ Connecting the AM loop antenna
1 Set up the AM loop antenna.
2 Press and hold the tab of the AM ANT
terminal.
3 Insert one of the AM loop antenna lead wires
into the AM ANT terminal.
4 Release the tab of the AM ANT terminal back
into place.
5 Repeat steps 2 through 4 to connect the
other lead wire to the GND terminal.
y
Once you have properly connected the AM loop antenna to
this unit, orient the AM loop antenna for the best reception
when you tune into AM stations (see page 52).
Connecting the FM and AM antennas
Notes
75Ω UNBAL.
FM
ANT
AM
ANT
GND
TUNER
Indoor FM antenna
Ground (GND terminal)
For maximum safety and minimum interference, connect the
antenna
GND terminal to a good earth ground. A good earth
ground is a metal stake driven into moist earth.
AM loop antenna
(U.S.A. model)
Outdoor AM antenna
Use a 5 to 10 m (16.4 to 32.8 ft)
of vinyl-covered wire extended
outdoors from a window.