Filter
Top Products
79
EDITING SOUND FIELD PARAMETERS
ADDITIONAL
INFORMATION
4 Press u / d to select
the parameters.
5 Press j / i to change
the parameter value.
When you set a parameter
to a value other than the
factory-set value, an
asterisk mark (*) appears
by the parameter name on
the on-screen display.
y
If you press and hold j / i to change the parameter value, the
front panel display automatically stops at the factory preset
parameter momently.
6 Repeat steps 3 through 5 as necessary to
change other program parameters.
You cannot change parameter values when “MEMORY
GUARD” is set to ON. If you want to change the parameter
values, set “MEMORY GUARD” to OFF (see page 70).
■ Resetting parameters to the factory
presets
Use PARAM. INI (see page 71).
Note
Memory back-up
The memory back-up circuit prevents the stored data
from being lost even if this unit is set in the standby
mode, the power cord is disconnected from the AC
outlet, or the power supply is temporarily cut due to
power failure. However, if the power is cut for more
than one week, the parameter values will return to the
factory settings. If this happens, edit the parameter
value again.
A-E/CAT. A-E/CAT.
ENTER
PRESET/CH
A-E/CAT. A-E/CAT.
ENTER
PRESET/CH
01EN_HTR-5860_U.book Page 79 Thursday, December 30, 2004 12:27 PM