Filter
Top Products
25
AUTO SETUP
PREPARATION
For best results, make sure the room is as quiet as possible
during the auto setup procedure (YPAO). If there is too
much ambient noise, the results may not be satisfactory.
y
If your subwoofer has adjustable volume and crossover/high cut
frequency controls, set the volume between 9 and 11 o’clock (as
viewed on a conventional clockface) and set the crossover/high
cut frequency to the maximum.
1 Switch on this unit and your video monitor.
Make sure the OSD is displayed.
2 Press AMP.
3 Press SET MENU.
y
When MEMORY GUARD is set to ON, you cannot select
any other SET MENU items (see page 60).
4 Press u / d to select AUTO SETUP, then
press ENTER.
5 Press u / d to select “SETUP”, then press
j / i to select the desired setting.
AUTO To perform the auto setup procedure
(YPAO).
RELOAD To reload the last auto setup (YPAO)
settings to override any manual
changes.
UNDO To undo the last auto setup (YPAO)
and restore the previous settings.
DEFAULT To restore the factory preset (default)
setup parameters.
y
You can choose RELOAD or UNDO only if you have
already performed the auto setup procedure.
6 Press d to select “START”, then press
ENTER to start the setup procedure.
The screen changes as follows.
Starting the setup
VOLUME
MIN
MAX
CROSSOVER/
HIGH CUT
50Hz
150Hz
Subwoofer
AMP
MENU
SET MENU
SRCH MODE
A-E/CAT. A-E/CAT.
ENTER
PRESET/CH
SET MENU
.;AUTOSETUP
;MANUALSETUP
;SIGNAL INFO.
[ ]/[ ]:Up/Down
[ENTER]:Enter
p
p
A-E/CAT. A-E/CAT.
ENTER
PRESET/CH
1 AUTO:MENU
. SETUP;;;;;;;AUTO
START
Automatic
processing
of all items
[ ]/[ ]:Up/Down
[<]/[>]:Select
p
p
2 AUTO:CHECK
WIRING
INITIALZING
.
SIZE/DISTANCE.
EQUALIZING.
LEVEL.
CHECK CH=CENTER
|||||;;;;;;;;
[]:Exit
p
.WARNING (3)
RESULT
SP : 5/4/0.1
DIST: 10.0/ 12.0ft
LVL : -9.0/ +6.5dB
.>SET CANCEL
[]/[]:Up/Down
[ENTER]:Enter
p
p
RESULT:EXIT
1 AUTO:MENU
SETUP;;;;;;;AUTO
.START
Automatic
processing
of all items
[]/[]:Up/Down
[ENTER]:Start
p
p
01EN_HTR-5860_U.book Page 25 Thursday, December 30, 2004 12:27 PM