Filter
Top Products
TX6n/5n/4n Reference Manual
21
Panel Operations
■ Information
This screen shows information about the amplifier. This is only for display, and contains no editable parameters.
■ Network Setup
Here you can specify the IP address and other settings for using the amplifier in a network.
Parameter name Explanation
Battery Indicates the state of the internal backup battery in four levels: “OK,” “Low Battery,” “Critical Battery,”
or “No Battery.” If “Critical Battery” or “No Battery” is shown, immediately save the data to a computer
or other external device, and then ask a Yamaha dealer to replace the backup battery.
Version Indicates the firmware version.
Serial No. Indicates the serial number of the amplifier.
Slot Indicates the name of the card installed in the slot. By default, an AES-IO card is installed.
Parameter name Range Explanation
IP Address Mode DHCP/Manual Specifies whether the IP address will be set automatically from Amp
Editor or the DHCP server (DHCP), or set manually (Manual).
IP Address 001.000.000.001–
223.255.255.254
Indicates the IP address for Auto mode.
Specifies the IP address for Manual mode. If you attempt to specify an
invalid address, the setting will be cancelled even if you press the
[ENTER] button.
MAC Address — Indicates the MAC address.
IP Control Port No. 49152–49407 Specifies the Ethernet port number that will be used for remote control
from an external remote controller via the dedicated communication pro-
tocol. All devices in the network can communicate over the same port
number. Change the port number if the same port number is used for
other devices (other than TXn).