Filter
Top Products
En 110
The unit cannot be controlled using the remote
control.
The unit is out of the operating range. Use the remote control within the operating range (p.5).
The batteries are weak. Replace with new batteries.
The unit’s remote control sensor is exposed to direct sunlight or
strong lighting.
Adjust the lighting angle, or reposition the unit.
The remote control IDs of the unit and the remote control are not
identical.
Change the remote control ID of the unit or the remote control (p.104).
The remote control is set to the Zone2 operation mode. Set the remote control to the Main zone operation mode (p.75).
An input source cannot be selected using the
INPUT knob on the front panel.
The “Input Skip” function has been applied to that input source.
Set the “Input Skip” function in the setup menu (p.97) to “Off” for that input
source, or select the input source using the input selection key on the remote
control.
The RED/GREEN/YELLOW/BLUE keys of the
remote control do not function.
The device which is connected to the unit via HDMI does not
support the function of the RED/GREEN/YELLOW/BLUE keys.
Use a device which supports the function of the RED/GREEN/YELLOW/BLUE
keys.
The settings of the RED/GREEN/YELLOW/BLUE keys of the unit's
remote control have been changed.
Set the “Remote Color Key” settings in the “Setup” menu to “Default” (p.98).
Problem Cause Remedy