Filter
Top Products
En 103
Configure the system settings of the unit while viewing the front display.
1
Set the unit to standby mode.
2
While holding down STRAIGHT on the front panel, press
z (power).
3
Press PROGRAM to select an item.
4
Press STRAIGHT to select a setting.
5
Press z (power) to set the unit to standby mode and turn it on again.
The new settings take effect.
ADVANCED SETUP menu items
• Default settings are underlined.
Changing the speaker impedance setting (SP IMP.)
Change the unit’s speaker impedance settings depending on the impedance of the
speakers connected.
Settings
Configuring the system settings (ADVANCED SETUP menu)
z (power)
STRAIGHT
PROGRAM
Item Function Page
SP IMP. Changes the speaker impedance setting. 103
REMOTE ID Selects the unit’s remote control ID. 104
TU
(Asia and General models only)
Changes the FM/AM tuning frequency setting.
104
TV FORMAT Switches the video signal type of HDMI output. 104
INIT Restores the default settings. 104
UPDATE Updates the firmware. 105
VERSION Checks the version of firmware currently installed on the unit. 105
6
Ω MIN Select this option when you connect 6-ohm speakers to the unit.
8 Ω MIN
Select this option when you connect 8-ohm or higher speakers to the
unit.
VOL.
MUTE
ENHANCER
STEREO
TUNED
SLEEP
OUT
ECO
CHARGE
ADAPTIVE DRC
VIRTUAL
SP IMP.••6¬MIN