Filter
Top Products
E-49
English
HOW TO USE THE BUILT-IN TIMER
TIMER PLAY
By using the built-in timer, you can set the time when
this system turns on and a source begins playing
automatically, and the time when this system turns into
the standby mode automatically.
1 Prepare the source to be played.
For tuner:
Tune in to the station you will listen to.
For CD player:
Load a disc on the disc tray.
2 Press the DISPLAY button.
Whenever the DISPLAY button is pressed, the
display mode changes as follows.
On each mode, make a setting for the timer play,
following the setting procedure described below.
➀ Current time (TIMER on/off mode)
➁ Source selecting mode (TUNER, CD)
➂ ON TIME/Time setting mode
➃ OFF TIME/Time setting mode
➄ Normal display mode
Note
The display mode will be changed to the next
mode after about 8 seconds elapse in turn
automatically. If the mode is changed before the
setting is completed, call the mode again by
pressing the DISPLAY button once or more.
Setting procedure:
➀ Current time
Check to be sure that the current time is correct,
and press the TIMER button so that “TIMER”
lights up on the display.
➁ Source selecting mode
Select the source (TUNER or CD) to be played
by pressing the corresponding input selector
button.
* If “TUNER” is selected, soon it is changed to
the frequency display mode. In this mode, you
can select the station to listen to by the timer
play by using the PRESET/BAND button and
/ button.
→
→→→→
POWER
SLEEP
VOLUME
TEST
ON/OFF
C/R/D
CENTER/REAR
/DELAY
PRESET
TUNER
CD
DSP
LEVEL
PROGRAM
SUBWOOFER
INPUT
AMP
2-➀
22-➁
2-➁
PONENT SYSTEM AV–1
OPEN
/
CLOSE
CD
TUNER TAPE
/
MD VCR
/
TRACK PRESET
PRO LOGIC DSP OFF
ENHANCED MONO MOVIE
ROCK CONCERT VIDEO
DISCO HALL STADIUM
MEMORY
TIME ADJ
AUTO/MAN’L
TIMER
PRESET/BAND
HOUR MIN
REPEAT
DISPLAY
//
VIDEO 2