Filter
Top Products
E-29
English
ENJOYING LISTENING TO A SOURCE
To finish listening to a source
1 Stop playing a source.
2 Press the VOLUME “ ” (or “–”) button to decrease
the volume to minimum until “MIN” is shown on the
display.
3 Press the POWER switch to turn this system into the
standby mode.
* In this mode, only the time is shown on the
display.
Adjusting the subwoofer output level
According as you prefer, adjust the subwoofer output
level by pressing the SUBWOOFER level + (up) or –
(down) button.
If you feel that bass tone is insufficient, increase the
level, and if you feel that bass tone is overly
emphasized, decrease the level.
Listening with headphones
●
Be sure that your headphones have a 3.5 mm (1/8”)
diameter plug and are between 16 ohms and 50
ohms impedance. Recommended impedance is 32
ohms.
●
When you listen with headphones, connect the
headphones to the PHONES jack. You can listen to
the sound to be output from the front speakers
through headphones.
When listening with headphones privately, switch off
the digital sound field processor (so that no DSP
program name is illuminated on the display) by
pressing the DSP ON/OFF button on the remote
control transmitter. Adjust the VOLUME buttons for
desired volume.
MINI COMPONENT SYSTEM AV–1
POWER
PUSH
OPEN
/
CLOSE
MEMORY
TIME ADJ
AUTO/MAN’L
TIMER
PRESET/BAND
HOUR MIN
REPEAT
DISPLAY
//
VIDEO 2
PHONES
OPEN
/
CLOSE
CD
TUNER TAPE
/
MD VCR VIDEO 1 VIDEO 2
/
VOLUME
MHz
K
Hz
TRACK PRESET
PRO LOGIC DSP OFF
ENHANCED MONO MOVIE
ROCK CONCERT VIDEO
DISCO HALL STADIUM
TIMER
F REP
SLEEP
AUTO ST
MEMORY
PTY HOLD
POWER
SLEEP
VOLUME
TEST
ON/OFF
C/R/D
CENTER/REAR
/DELAY
PRESET
TUNER
CD
DSP
LEVEL
PROGRAM
SUBWOOFER
INPUT
AMP
MINI COMPONENT SYSTEM AV–1
POWER
PUSH
OPEN
/
CLOSE
C
MEMORY
TIME ADJ
AUTO/MAN’L
TIMER
PRESET/BAND
HOUR MIN
REPEAT
DISPLAY
//
VIDEO 2
PHONES
PHONES
3
2
3
2
SUBWOOFER
– / +