Filter
Top Products
E-14
Connect the provided speakers (NX-AV1) to the
SPEAKERS terminals on the rear of SW-AV1.
All of the speakers (NX-AV1) are identical.
The speakers connected to the FRONT R and L
terminals should be used as the right and left front
speakers.
The speaker connected to the CENTER terminal
should be used as the center speaker.
The speakers connected to the REAR R and L
terminals should be used as the right and left rear
speakers.
Notes
● Do not connect speakers other than the provided
ones to SW-AV1.
● Use the provided speaker cords for the connections.
Normally, use the short cords to connect with the
front and center speakers, and use the long ones to
connect with the rear speakers.
● The provided tag sheet for speaker cords is useful
for preventing wrong connections between speakers
and SW-AV1.
How to Connect:
Connect the provided speaker cords between the
SPEAKERS terminals on the power
amplifier/subwoofer (SW-AV1) and the speaker
terminals on each speaker (NX-AV1) properly as
shown below. If the connections are faulty, no sound
will be heard from the speakers. Make sure that the
polarity of the speaker wires is correct, that is the + and
– markings are observed. If these wires are reversed,
the sound will be unnatural and lack bass.
As a sure method, connect the wire with a silver line to
the + terminals on both the power amplifier/subwoofer
(SW-AV1) and speaker, and connect the wire with no
line to the – terminals on both of them.
Caution
Do not let the bare speaker wires touch each other
as this could damage SW-AV1 and/or speakers.
On SW-AV1:
Red: positive (+)
Black: negative (–)
➀
Press up the tab.
➁
Insert the bare wire.
[Remove approx.
5mm (1/4”)
insulation from the
speaker wires.]
➂
Press down the tab
and secure the
wire.
On NX-AV1:
Red: positive (+)
Black: negative (–)
➀
Press the tab.
➁
Insert the bare wire.
[Remove approx.
5mm (1/4”)
insulation from the
speaker wires.]
➂
Release the tab and
secure the wire.
CONNECTIONS
➀
➁
➂
L
FRONT