Filter
Top Products
MRC88 / MRAUDIO8X8 QUICK START GUIDE
08905142A
15
SPEAKERS
Head End Connections
Use the included 4-conductor plug-in connectors, (6 included) to connect speaker
wires to the MRC88.
1. Strip each speaker wire conductor’s insulation back about ¼ inch (6mm) and
twist the ends to prevent fraying.
2. Insert the leads into the appropriate “L+, L-”/“R+, R-” Terminals on each
plug-in connector. Confirm polarity. Slightly pull the connected wire to
confirm connection.
3. Be sure there are no loose strands that can cause shorts.
4. Plug the connector into the appropriate Zone Speaker Terminal.
5. Repeat for all zones.
Zone Connections
Prior to connecting speakers, be sure ceiling/wall openings have been properly
prepared and that any required mounting hardware is in place.
1. Strip each speaker wire conductor’s insulation back about ¼ inch (6mm) and
twist the ends to prevent fraying.
2. Connect the leads to the appropriate “L+, L-”/“R+, R-” Terminals on each
speaker. Confirm polarity. Slightly pull the connected wire to confirm
connection.
3. Be sure there are no loose strands that can cause shorts.
4. Install speakers per manufacturer’s instructions.
5. Repeat for all speakers in all zones.
Figure 12 – Zone Speaker Connections