Filter
Top Products
Wolf Cinema Owner's Manual
2-15
As an alternative to the projector’s keypad or remote, you may wish to communicate with the
projector using a PC or other controller. Such a device sends commands and receives feedback
via serial links (RS232 and RS422), Ethernet or GPIO communications to the projector, all
described below.
As desired, direct the projector’s IR remote keypad towards the display screen or the projector’s
IR sensors. Alternatively, connect a wired (tethered) version of the remote to the 3.5mm RCA
jack labeled as REMOTE on the projector’s input panel. Note that response to a wired keypad
must also be enabled in the Communications menu — see 3.6, Adjusting System Parameters
and Advanced Controls for more information.
There are two types of serial ports available on the projector: RS232 and RS422. You can connect
a device with a serial interface, such as a computer to either of these connectors (not both) and
controltheprojectorremotelybyenteringspecicserialcommunicationcommands.
Connecting RS-232
The two nine-pin DIN connectors labeled RS232 IN and RS232 OUT on the input panel are
dedicated to serial communication (see Figure 2.10). Using the appropriate serial communication
cables (see Appendix C) connect the controlling source, such as a personal computer to the
RS232 IN connector. Then set the baud rate to match that of the computer. Refer to Section 3
for details on changing the projector’s baud rate.
Remote Keypads >
Serial Port Connections >
Figure 2.10 Connecting RS-232
From WC-Pro Processor
Section2►InstallationandSetup
2.4 Connecting
Communications