Wolf DCX-1500I Home Theater System User Manual


  Open as PDF
of 152
 
Wolf Cinema Owner's Manual
B-42
3.132 SAV
Save Change
SAV Save Changes
The projector normally saves any changes every few minutes and with every power-down.
Use SAV to save changes immediately, and to retain them in the event of a power failure.
Theprojectorwillsaveintoashmemoryalloutstandingchanges.TheSAVmessagehasno
parameters.
SBE Slidebar Enable
Use SBE to show (1) or hide (0) slidebars during use.
SDE Source Dialog Enable
Use SDE to show (1) or hide (0) the on-screen dialog box when selecting an input using
numbered keypad entry.
SHU Shutter
Use SHU to open (0) or close (1) any installed shutter mechanism.
SIN Select Input
UseSINtoswitchtoaspecicinput.
1 = BNC
2 = DVI-I
3 = Composite
4 = S-Video
5 = Option slot #1
6 = Option slot #2
7 = Option slot #1 – its secondary input if present
8 = Option slot #2 – its secondary input if present
SIZ Size
Use SIZ to control image width and height in tandem, maintaining the incoming aspect ratio
(1000 = no resizing).
SOR Screen Orientation
Use SOR to specify the orientation of the projector in relation to the screen.
0 = Front
1 = Rear
2 = Ceiling Front
3 = Ceiling Rear
SPS Splash Select
Use SPS to select when to display the splash screen.
0 = Off
1 = Startup only
2 = Startup and no signal (default)
3 = Always on
SRC Select Source
UseSRCtoswitchtoaspecicsourcesetup##(1-50).ThisisthesameasCHAcommand.
3.133 SBE
Slidebar Enable
3.134 SDE
Source Dialog Enable
3.135 SHU
Shutter
3.136 SIN
Select Input
3.137 SIZ
Size
3.138 SOR
Screen Orientation
3.139 SPS
Splash Select
3.140 SRC
Select Source
AppendixB►SerialCommunications
 previous next