4
42
• Choose option 3 (Installation Settings).
• On the Installation Settings menu, choose option 2 (Set Remote Control
Address). Now follow the instructions on the Remote Control Address screen.
• If you have four receivers, you will have to change the addresses on three of
them: they will have addresses of 000, 001, 002, and 003.
To program your remote control for each receiver, hold down the CBL key on the
remote control until the light flashes. Once the light begins to flash, enter the
desired address.
Cable Frequency Plan. This option allows you to select the appropriate
frequency plan for a network—Standard or HRC.
Cable Channel Plan. This option allows you to select the appropriate
frequency plan for the given network. Selection A is the EAI channel plan, and
selection B is the General Instrument/Motorola BCS channel plan.