3
24
Programming the Remote Control
The remote control is set at the factory to control all of the receiver functions, but
to use it to operate your TV, you must "program" it for the brand you own. Follow
these instructions to program the remote to control your TV.
1. Turn on the TV for programming.
2. Use the table that appears later in this section to find the brand of TV.
3. After the manufacturer’s brand name is a three-digit code number (or
several three-digit codes).
4. Press and hold the TV key on the remote control for at least three
seconds or until the light on your remote flashes.
5. If the remote control "accepts" the code, you will see several rapid
flashes of the light. If it does not flash, repeat steps 3 and 4. After the
remote control accepts the code, press the POWER key on the remote
control to make sure the remote control is able to turn your
component off. This means it is functioning properly.
6. If your component does not respond to the remote control POWER
key, even though it has "accepted" the manufacturer’s code, repeat
steps 3 and 4 using the second three-digit code from the table. If this
does not work, try the third code, etc., until the remote control accepts
the code and your component responds to the remote control POWER
key.