Filter
Top Products
DSR470 User Guide 31
4
Installation
Connecting the Cable, Receiver, and TV
Complete the following steps and make sure that the receiver is not plugged into a
power source before you connect any cables to the receiver:
• Connect thecable from the cable TV outlet onthe wall to the cable terminal on
the digital receiver’s back panel. Connect the supplied coaxial cable to VHF
IN terminal on your TV and to the Out to TV connector on the receiver.
• On the back panel of the receiver, set the CH3 CH4 switch, which is located
just above the TV terminal, to the same channel that you set on your TV for
use with your VCR.
• Turn on the TVand tune it to channel 3 or 4 to match the position of the switch
on the back panel of the receiver.
• Plug the receiver power cord into a standard power outlet. Wait one minute,
then press the POWER key (green) on the left side of the receiver's front panel.
Front Panel Descriptions
Most viewers find it more convenient to use the keys on the remote control rather
than the keys on the front panel of the receiver. But even though there are far
fewer keys on the receiver, they still allow you to control most receiver functions.