Filter
Top Products
37
Playback
Recording
Function setup
Others
Introduction
Library
Editing
Entering characters
The cursor may be followed by unwanted characters.
You can erase them if necessary by either of the
following measures:
Erasing characters
• Erasing all the characters on the writing board
Select “Clear All” by pressing
/ / / buttons, then
press ENTER button.
Alternatively, press CLEAR button.
• Erasing one character before the cursor
Select “BkSp” by pressing
/ / / buttons, then
press ENTER button.
Alternatively, press DELETE button.
(1) Press
button to select an input mode.
(2) Press
/ / / buttons to select a character, then
press ENTER button.
The selected character is input on the cursor.
(3) Repeat steps (1) and (2) to enter characters.
(4) When finished, press
button to save the
characters.
The characters you entered appears.
Notes
• You can enter up to 64 characters.
• When unnecessary information appears, or when you want
to alter the input character, press CLEAR button to erase
all, or press DELETE button to erase an unnecessary
character.