Filter
Top Products
WARNINGSWARNINGS
This symbol is intended to alert you to the
presence of uninsulated dangerous
voltage within the product's enclosure
that might be of sufficient magnitude to
constitute a risk of electric shock. Do not
open the product's case.
This symbol is intended to inform you
that important operating and
maintenance instructions are included in
the literature accompanying this product.
CAUTION
TO PREVENT ELECTRONIC SHOCK, DO NOT USE
THIS (POLARIZED) PLUG WITH AN EXTENSION
CORD, RECEPTACLE OR OTHER OUTLET UNLESS
THE PLUG CAN BE FULLY INSERTED WITHOUT
EXPOSINGANY PARTS OF THE BLADES.
WARNING
To prevent fire or shock hazard, do not expose this
appliance to rain or moisture.
The apparatus shall not be exposed to dripping or
slashing and that no objects filled with liquids, such as
vases, shall be placed on the apparatus.
The ventilation should not be impeded by covering the
ventilation openings with items, such as newspapers,
table-cloths, curtains, etc.
No naked flame sources, such as lighted candles,
should be placed on the apparatus.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesirable
operation.
This DVD/CD+G player is made and tested to meet
safety standards of the FCC, requirements and
compliance with safety performance of the U.S.
Department of Health and Human Services, and also
with FDA Radiation Performance Standards 21 CFR
Subchapter J.
Warnings:
CAUTION
CAUTION!
!
!
!
This DVD/CD+G player employs a laser light beam.
Only a qualified service person should remove the
cover or attempt to service this device, due to possible
eye injury.
The use of controls, adjustments, or procedures other
than those specified herein might result in hazardous
radiation exposure.
This DVD/CD+G player is classified as a CLASS 1
LASER product.
The CLASS 1 LASER PRODUCT label is located on
the rear panel.
Invisible laser radiation when open and interlocks are
defeated.Avoid exposure to beam.
IMPORTANT
Since CD circuitry may cause interference to other
radio tuners nearby, switch this unit off when not in use
or move it away from the affected radio tuner.
This class[B] digital apparatus complies with
Canadian ICES-003.
The apparatus shall be used in an open area.
WARNING: TO REDUCE THE RISK OF FIRE OR
SHOCK HAZARD, DO NOT EXPOSETHIS PRODUCT TO
RAIN ORMOISTURE.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO PREVENT THE RISK OF
ELECTRIC SHOCK, DO NOT REMOVE COVER
OR BACK. NO USER-SERVICEABLE PARTS
INSIDE. REFER SERVICING TO QUALIFIED
PERSONNEL.
E1
The CAUTION marking is located on the rear panel.
WARNING
AUTOMATIC DEGAUSSING
NOTE: This digital apparatus does not exceed theClass B limits for radio noiseemissions from thedigital apparatus
as set out in the Radio Interference Regulations of Industry in Canada. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television (which can be
determined by turning the equipment off), the user is encouraged to try to correct the interference by one or more of
the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio / TV technician for help.
!
!
!
!
All color television receivers are sensitive to magneticinfluences, usually caused byeither moving the receiverfrom
one place to another or using certain electrical appliances near the receiver. The residual magnetism as it is called,
sometimes causes distortion which gives rise to “blotchy” areas of color in the picture. To avoid these effects the
receiver incorporates an automatic degaussing circuit which operates for a short while immediately each time the
receiver is switched on using the main switch. This circuit removes any residual magnetism in the metal parts of the
picture tube and therefore ensures that each time the receiver is switched on. If the set is moved or faced in a
different direction, the main switch must be switched off for at least 10 minutes in order for the automatic degaussing
circuit to operate properly.
ENGLISH