Filter
Top Products
E12
CONNECTIONS
CONNECTING POWER
CAUTION:
CONNECTING TOYOUR HEADPHONE
CONNECT YOUR GUITARAND KEYBOARD
You can power the system from a standardAC outlet by using the supplied power cord.
The supplied AC power cord has a polarized plug that fits into the wall outlet only one way. If the plug
does not fit properly, turn it over and try again. Do not force it.
A headphone jack is provided for using headphones instead of the built-in speakers. (Headphones are sold
separately.)
1. Connect the guitar or keyboard to guitar input jack or keyboard input jack.
2. Press the POWER button to turn the unit on.
3. The sensitivity and loudness could be adjusted as required by turning the guitar or keyboard volume control
and/or the master volume control.
PRIOR TO CONNECTING
!
!
Always turn off the Singing Machine,TV and other components before connecting or disconnecting any cables.
Please refer to the instructions below along with the instruction manual for the other component if connection
problems occur or more information is needed.
CONNECTING TO A VIDEO SYSTEM
CONNECTINGAVIDEO COMPONENT FOROUTPUT
NOTE
COMMON WAYS TO CONFIGUREYOUR TV OR VCR
: To display only the image on another video system, disconnect the
. The audio signal will originate from the built-in speakers on the unit.
Please use the provided CDG disc to test the connections. The lyrics and music of songs on the disc will be
displayed on the Singing Machine.
If you have never used the video input RCA jack or coaxial cable on your TV/VCR you should consult your
TV/VCR user guide. If you don’t have your manual, please contact your TV/VCR manufacturer for information
either by phone or by viewing their website for online assistance. They will be able to tell you very quickly how to
configure your TV or VCR to display the video connection.
The three most common ways to set up the TV/VCR are:
1) A ‘Video’ button may be on the TV/VCR or on the remote control. Pressing ‘Video’ may display the input from
your Singing Machine.
2) Try looking for a ‘Video’ channel between the regular channels on your TV/VCR. Do this by setting the channel
on the TV/VCR to channel 2 then pressing the ‘Down’ channel button to see if there is a ‘Video In’ or ‘Line In’
between the lowest channel and the highest channel on your system.
3) The configuration may also be located in the set-up menu on the TV/VCR. Look for a section on ‘Input
Selection’where you might be able to choose the input source i.e.’Cable/Ant.’, ‘Video 1’, ‘Line In’or ‘Video In’.
Please follow the steps below to share your Singing Machine display on another video system:
(1) Locate the multicolor RCApatch cords.
(2) Connect yellow video cable to the Video Output jack, red audio cable to the Audio Right channel Output jack
and white audio cable to theAudio Left channel Output jack respectively on the back of the Singing Machine.
(3) Connect the other end of the cords to the Video Input jack,AUX Right/Left channel Input jacks on your video
system relatively.
Audio/AUX Right and Left channel
(Red and White) Output RCAcables
REAR VIEW OF
VIDEO SYSTEM
OUT
IN
LR
VIDEO
AV 1
AUDIO
LR
VIDEO
AUDIO
AUX IN
L
R
VIDEO
IN
VIDEO OUT
(Yellow Jack)
AUDIO OUT
R
(Red Jack)
AUDIO OUT
L
(White Jack)
VIDEO IN
(Yellow Jack)
AUX IN
R
(Red Jack)
AUX IN
L
(White Jack)
REAR VIEW OF
SINGING MACHINE
ENGLISH