6
RQT6894
Simple setup
Simple setup
STEP1 Locating
Components
DVD/Video CD/CD changer Sound processor
Stereo cassette deck Stereo tuner/amplifier
Sound processor
Stereo tuner/amplifier
DVD/Video CD/CD changer
Stereo cassette deck
A
D
C
B
E
Speakers
Optimum location
Distance: ANBNCNDNE
Front speaker (left)
Center speaker
Front speaker (right)
Surround speaker (left) Surround speaker (right)
Note
Do not put the DVD/Video CD/CD changer on the top of the tuner/ampli-
fier. Heat can damage your discs.
Use only the supplied speakers.
Using other speakers can damage the unit and sound quality will be neg-
atively affected.
Caution
pUse the speakers only with the recommended system.
Failure to do so may lead to damage to the amplifier and/or the
speakers, and may result in the risk of fire.
Consult a qualified service person if damage has occurred or if
you experience a sudden change in performance.
pDo not attempt to attach these speakers to walls using meth-
ods other than those described in this manual.
Front speakers
Left and right front speakers are exactly same.
Surround speakers
Place either side of the listening position, or slightly to the rear, about
1 meter higher than ear level with the Technics logo facing toward the
listening position.
The effect varies with the type of music and the music source.
If you are unable to position the surround speakers as recommended, you
can put them near the front speakers and still achieve a surround-like
effect (➡ page 34, VIRTUAL REAR SURROUND).
Attaching to a wall
Set the speaker onto screws and slide through bracket to lock into
position.
Note
The wall or pillar on which the speakers are to be attached should be
capable of supporting 5 kg per screw.
Notes on speaker use
w You can damage your speakers and shorten their useful life if you play
sound at high levels over extended periods.
w Reduce the volume in the following cases to avoid damage.
pWhen playing distorted sound.
pWhen the speakers are receiving howling from a microphone (for
Australia and N.Z.) or record player, noise from FM broadcasts, or
continuous signals from an oscillator, test disc, or electronic in-
strument.
pWhen adjusting the sound quality.
pWhen turning the unit on or off.
If irregular colouring occurs on your television
These speakers are designed to be used close to a television, but the
picture may be affected with some televisions and set-up combinations.
If this occurs, turn the television off for about 30 minutes.
The television’s demagnetizing function should correct the problem.
If it persists, move the speakers further away from the television.
70 mm
30–35 mm
7.5–9.5 mm
7–9 mm