28
RQT6894
Basic operations
C
A
1
2
3
MHz
SET
SET
SET
TUNER/
BAND
VOLUME
1
23
4
56
7
890
10/-/--
,
SET
TUNING MODE
TUNING
CANCEL
PLAY MODE
MIX 2CH
AUDIO
TAPE/
DECK 1/ 2
DVD
TUNER/
BAND
SLEEP
TOP MENU
MENU
PLAY LIST
EQ
SUPER
SOUND EQ
SUBTITLE
POSITION MEMORY
SETUP
GROUP
1
23
DISC
4
56
7
890
CH SELECT
TEST
SUPER SRND
10/-/--
/
VCR(EXT)/
VDP(AUX)
MUTING
SLOW/SEARCH
DIGITAL
S.WOOFER
SKIP
VOLUME
ENTER
SHIFT
S. 3D AI EQ
DISPLAY
DIRECT
NAVIGATOR
AV EFFECT
RETURN
PRO LOGIC
2
1
3
B
The radio: preset tuning
There are two methods of presetting stations.
Automatic presetting: The stations the tuner can receive are preset.
Manual presetting: You can select the stations to preset and the order
they are preset in.
There are 39 channels available for presetting.
ª
A
Automatic presetting
Do the following once each for FM and AM.
Preparation: Tune to the frequency presetting is to begin at (➡ page 27).
Hold down [SET].
Release the button when “AUTO MEMORY” appears on the tuner/amplifier.
The tuner presets all the stations it can receive into the channels in ascend-
ing order. FM stations are preset into channels 1 to 39, and AM stations are
preset into channels 21 to 39.
“SET OK” is shown when presetting is complete and the last station to be
preset is played.
“ERROR” is displayed if the tuner doesn’t receive any stations. Do preset-
ting manually if this happens (see below).
Note
AM stations replace any FM channels that were preset in channels 21
to 39.
ª
B
Manual presetting
Preset the stations one at a time.
1 Tune to the required station.
2 Press [SET].
3 Press [TUNING (X or W)] to select a channel.
4 Press [SET].
The station occupying a channel is erased if another station is preset in that
channel.
ª
C
Selecting channels
Preparation: Press [Í] to turn the unit on.
On the remote control
1 Press [TUNER/BAND].
2 Press the numbered buttons to select the
channel.
For channels 1 to 9 press the corresponding number.
For channels 10 or over press [S10/-/--], then the two digits.
e.g. To select channel 21: [S10/-/--]>[2]>[1]
3 Adjust the volume.
On the main unit
1 Select “PRESET” with [TUNING MODE].
2 Press [TUNING (X or W)] to select the channel.