Filter
Top Products
42 TASCAM CD-A550/CD-A750
Continuous playback of both the CD
and the tape
This unit can alternately play the loaded CD and the
cassette tape. In other words, tape playback starts when CD
playback ends and CD playback starts when tape playback
ends.
Before using the following procedures, load a recorded
cassette tape and a CD.
1 Press the CD-TAPE CONT PLAY key on the main unit
or the CONT PLAY key on the remote control.
CD-TAPE CONT PLAY key
CONT PLAY key
2 Press the CD or TAPE PLAY key.
TAPE PLAY key
CD PLAY key
TAPE PLAY key
CD PLAY key
Depending on the key pressed, the CD or tape begins to
play. When playback of the selected media ends, playback
of the other media automatically starts.
During continuous playback mode, the CONT PLAY indicator
appears on the display, and the indicator for the media
currently being played (TAPE or CD) blinks.
CONT PLAY display
If you press the TAPE STOP key to manually stop play-
•
back, the other media automatically starts playing.
When playing a CD in REPEAT mode, tape playback
•
does not start until you manually stop the CD
playback. Likewise, when the tape is in auto reverse
mode (ä), CD playback does not start until both
sides of the tape have played five times or playback is
stopped manually.
3 To stop using continuous playback mode, press the
CD-TAPE CONT PLAY key on the main unit or the
CONT PLAY key on the remote control again.
If the factory default settings have not been changed,
the CD playback signal is output from the CD OUTPUT
jacks and the tape playback signal is output from the
COMMON OUTPUT jacks independently. Set the menu
COMMON OUT item to “MIX” or “AUTO” to output both
the tape and CD signals from the COMMON OUTPUT
jacks. (See “Setting the common output signal” on page
20.)
8 – Other Functions